Shinko Denshi LF124R, Operation Manual

Page: 12 / 154

1 How to Begin LF(R) Series Operation Manual
- 2 -
Do not apply excessive force to or impact the balance.
Doing so could damage or result in failure of the balance. Carefully place samples on the
balance.
Do not allow the balance to remain in an overloaded state
(o-Err indication).
Doing so could damage or result in failure of the balance. Remove the sample immediately.
Do not use volatile solvents.
The main unit could deform. Wipe the main unit using dry cloth or a cloth moistened with a
small amount of neutral detergent.
Do not install the balance in a place where it is directly
exposed to airflow from air-conditioning or heating equipment.
Due to changes in the ambient temperature, the balance could fail to accurately weigh
samples.
Do not install the balance in a place exposed to direct sunlight.
The internal temperature of the balance could rise and the balance could fail to accurately
weigh samples.
Do not install the balance where the floor is soft.
When a sample is placed on the balance, the balance could slant and fail to accurately weigh
samples.
Do not install the balance in a place where the ambient
temperature or humidity change significantly.
The balance could fail to accurately weigh samples. Use the balance at an ambient
temperature of 10 to 30°C and a relative humidity of 80% or lower.
Do not install the balance on an unstable platform or in a place
subject to vibration.
The balance could fail to accurately weigh samples. In addition, a sample could fall off the
weighing pan and injure someone.
Do not install the balance on an inclined surface.
The balance could fail to accurately weigh samples due to errors caused by the inclination.
Install the balance on a level surface.