Shinko Denshi LF124R, Operation Manual

Page: 88 / 154

5 Function Setting LF(R) Series Operation Manual
- 78 -
5-10 Interval Output Function
Use this function to output data at specified intervals. Set the interval time in
“hour:minute:second” form.
You can output time with measurement data. To output time, refer to Section 5.9 “Time
Output.”
1
Go to the function setting mode.
(Refer to Section 2-6 “Basics of Function
Settings.”)
Press and hold the [Function] key until “Func” is
displayed.
2
Set the output control to “Output once after a set
interval elapses” or “Output once in a stable state
after a set interval elapses.”
or
Press the [Function] key several times to select “71.o.c.”
Press the [Zero/Tare] key to select “A” or “b” and
then press the [Set] key.
71.o.c.A = Output once after a set interval
elapses
71.o.c.b = Output once in a stable state after a
set interval elapses
3
Bring up the interval function.
<Press and hold>
Press and hold the [Set] key until “Int.VAL” is displayed.
The interval time is displayed and the cursor is
located at the leftmost digit.
4
Set the interval time. Change the value at the location of the cursor using the
[Zero/Tare] key.
Press the [Function] key to move the cursor to the right. If
the cursor is at the rightmost digit, it returns to the
leftmost digit.
Pressing the [Print] key while making the setting
returns to the weight display without saving the
setting.
5
Save the setting and return to the weight display. Press the [Set] key.
The balance returns to the weight display.