Monitoring and Configuring the Printer
202
• If you select “auto”, the print job will be encrypted when encryption is pos-
sible.
• If you select “on”, Clear Text communication is not possible, and encryption
password must be set before encryption communication can be used.
❒
Encryption is possible when the security option is installed correctly and
the password is specified.
sntp
The printer clock can be synchronized with a NTP server clock using Simple Net-
work Time Protocol (SNTP). Use the “sntp” command to change SNTP settings.
❖
View settings
msh> sntp
❖
NTP server address configuration
You can specify the IP address of the NTP server.
msh> sntp server “IP_address”
❖
Interval configuration
msh> sntp interval “polling_time”
• You can specify the interval at which the printer synchronizes with the op-
erator-specified NTP server. The default is 60 minutes.
• The interval can be entered between 16 and 16,384 minutes.
• If you set 0, the printer synchronizes with the NTP server only when you
turn the printer on. After that, the printer does not synchronize with the NTP
server.
❖
Time-zone configuration
msh> sntp timezone “+/-hour_time”
• You can specify the time difference between the printer clock and NTP
server clock. Time is in 24-hour format.
spoolsw
Use the “spoolsw” command to configure Job Spool settings.
You can only specify diprint, lpr, ipp, ftp and smb protocol.
• The “spoolsw” command for configuring Job Spool settings is available only
when the optional hard disk is installed.
❖
View settings
The Job Spool setting appears.
