sauter equitherm EQJW245, Operating Manual

Page: 56 / 127

56/127 www.sauter-controls.com
EQJW245
Operation
Automatic mode – hot water preparation automatically changes the mode
according to the weekly programme that has been set. Automatic mode should be
selected in normal cases.
The right-hand positions of the bottom rotary switch allow you to change the
device settings. In these positions, the controller operates in automatic mode.
Setpoint adjustment for increased domestic water temperature •
Setpoint adjustment for normal domestic water temperature •
Enter weekly switching programme for domestic water •
Enter switching programme for confi gurable output (output terminal 8) •
One-off domestic water heating. •
Displays when automatic mode is set 4.1.1
To show the various displays described below, the bottom rotary switch must be
moved to one of the following positions (see section 4.1).
Off mode
Continuous heating to normal domestic water temperature
Continuous heating to increased domestic water temperature
Automatic mode
The middle rotary switch must be in one of the following positions (see section
2.1).
Back-up mode
Reduced mode
Normal mode
Automatic mode
14:22
After you select the position for the 1.
top rotary switch, the current time
appears. The current operating status
(here: sun for normal mode = daytime
operation) and the current status of
the outputs are shown on the lower
margin of the display (not illustrated
here, see section Error! Reference
source not found 2.5)