Sartorius Cubis MCE11201S, Operating Instructions Manual

Page: 46 / 79

46 Operating Instructions Cubis
®
MCE
System Settings
7.3.6 Parameters in the “Language” Main Menu
Parameters Setting values Explanation
LANGUAGE ENGLISH* English
DEUTSCH German
FRANCAIS French
ITALIANO Italian
ESPANOL Spanish
PORTUG. Portuguese
РYССKИИ Russian
POLSKI Polish
* Factory setting
7.3.7 Parameters in the “Unit 1”, “Unit 2”, “Unit 3”, and “Unit 4” Function Menus
Parameters Setting values Explanation
The availability of units may depend on national legislation and is therefore
country-specific.
NONE* Switches the toggle between weight units off for this position.
GRAMS –
Newton NONE* The configuration values for the [DISP.DIG.] parameter in the [BALANCE]
menu are saved for the scale interval ([DISP.DIG.] parameter see 7.3, 34).
ALL “Show all decimal places”: All decimal places are shown in the display.
LP.ON/OFF “Reduced by 1 decimal place for load change”: The last decimal place on the
display is switched off until stability is achieved.
DIVIS. 1 “Last decimal place of the 1st division”: The last decimal place always shows
the 1st division.
MINUS 1 “Last decimal place off”: The last decimal place is switched off and the
measured value is rounded up or down by one decimal place.
* Factory setting