Sanyo Denki SANMOTION 3E S, Instruction Manual, Page: 84 / 488

2. Specifications
2-17
■
Specifications
Speed control range 1: 5000 Note 2)
Frequency characteristics 2200Hz Note 3)
Allowable load inertia moment 10 times motor rotor inertia moment Note 4)
Note 2) Internal speed command
Note 3) In case of high-velocity sampling mode
Note 4) When the value exceeds the above allowable load inertia moment, please contact us.
■
Built-in functions (100/200 VAC, 400 VAC)
Protection functions
Over current, Current detection error, Overload, Regeneration error, Overheat
error, External overheating, Over voltage, Main circuit power low voltage, Main
circuit power supply open phase, Control power supply low voltage, Encoder
error, Over speed, Speed control error, Speed feedback error, Excessive position
deviation, Position command pulse error, Built-in memory error, Parameter error,
Cooling fan error
Digital operator Status display, Monitor display, Alarm display, Test operation
Dynamic brake circuit Built-in Note 5)
Regeneration process circuit Built-in Note 6)
Monitor
Speed monitor (VMON) 2.0 V±10 % (at 1,000 min
-1
)
Torque (Thrust) (TCMON) 2.0 V±10 % (at 100 %)
Note 5) For RS3C30, just DB signal output circuit is built in.
Note 6) For RS3C15/30, regenerative resistor is external type only.
■
Built-in functions (Power unit/Amplifier unit combination of 200 VAC-600 A, 400 VAC-800 A)
Protection functions
Over current, Current detection error, Overload, Regeneration error, Overheat
error, External overheating, Over voltage, Main circuit power low voltage, Main
circuit power supply open phase, Control power supply low voltage, Encoder
error, Over speed, Speed control error, Speed feedback error, Excessive position
deviation, Position command pulse error, Built-in memory error, Parameter error,
Cooling fan error
Digital operator
Status display, Monitor display, Alarm display, Parameter setting,
Test operation, Adjustment mode
Dynamic brake circuit Not included Note 7)
Regeneration process circuit Included Note 8)
Monitor
Speed monitor (VMON) 2.0 V±10 % (at 1,000 min -1 )
Torque (Thrust) (TCMON) 2.0 V±10 % (at 100 %)
Note 7) Only dynamic brake timing signal output circuit is included.
Note 8) Regenerative resistor is attached external.