Sanyo Denki SANMOTION 3E S, Instruction Manual, Page: 402 / 488

11. Selection
11-17
11.3.6 Connection of regenerative resistor
The connection method of a resistor corresponds with the connection number of the external
regeneration resistor selected by the 4) clause.
■
Connection of regenerative resistor
* Thermostat shall be connected to general input in CN2.
* For amplifier: capacity 75A/100A/150A (200VAC input type), mount an external regenerative
resistor to terminals of RB1 and RB2 after removing short-bar between RB1 and RB4.
* For RS3C02/05/10, mount an external regenerative resistor to terminals of RB1 and RB2 after
removing short-wire between RB1 and RB4.
* Do not connect short-wire between terminals of RB1 and RB2.
Connection Number
Ⅲ
Connection Number
Ⅳ
■
One resistance is connected.
Connect a thermostat to the
general-purpose input of CN1.
■
Series connection about two
resistances.
Connect a thermostat to the
general-purpose input of CN1.
Connection Number
Ⅴ
Connection Number
Ⅵ
■
Parallel connection about two
resistances.
Connect a thermostat to the
general-purpose input of CN1.
■
Series/ parallel connection about four
resistances.
Connect a thermostat to the
general-purpose input of CN1.
RB1
RB2
CNA or terminal block
CN1
Twist
CONT1 ～ 7(+)
CONT1
～ 7(-)
Twist
RB1
RB2
Twist
CNA or terminal block
RB1
RB2
Twist
CNA or terminal block
RB1
RB2
Twist
CNA or terminal block
R R R
TH
TH TH
R R
R R
R R
TH TH TH TH
TH TH
CONT1
～
7(+)
CONT1
～ 7(-)
CN1
Twist
CONT1
～
7(+)
CONT1
～ 7(-)
CN1
Twist
CONT1 ～ 7(+)
CONT1
～ 7(-)
CN1
Twist