Sanken Samco SVC06, Instruction Manual, Page: 96 / 136

- 94 -
7-2 Function Code List
– PID Function / Communication Function
Code No. Function Name Data Content
Setting
Resolution
Factory
Presets
User
Setting
Value
3203 External PID control selection 0: No external PID control
1: External control PID1
2: External control PID2
3: For factory adjustment
4: external controls PID1 and PID2
5: For factory adjustment
6: For factory adjustment 1 0
3204 External PID operation mode
selection 1: Operation interlocked with inverter operation
2: PID output after power input
3: PID output controlled by external terminals 1 1
3205 PID constitution selection 0: Without command value addition calculation
1: With command value addition calculation 1 0
3206 Command value addition
calculation PID control gain 0.01-100 0.01 1
3207 PID1/PID2 switching time 0.1 -6,000 minutes 0.1 minute 0.1
3301 Reading PID1 command value Read only 1 ---
3302 Reading PID1 feedback value Read only 1 ---
3303 Reading PID1 input deviation Read only 1 ---
3304 Reading PID1 output value Read only 1 ---
3305 Reading PID2 command value Read only 1 ---
3306 Reading PID2 feedback value Read only 1 ---
3307 Reading PID2 input deviation Read only 1 ---
3308 Reading PID2 output value Read only 1 ---
3309 For factory adjustment
3310 For factory adjustment
3311 For factory adjustment
3312 For factory adjustment
Communication function
4001 Message checksum 0: No
1: Yes 1 1
4003 Pull-up/down function selection 0: No
1: Yes 1 0
4004 Communication response time 1-6000ms 1ms 10
4005 Serial communication function 0:No function
1: Dedicated protocol communication function
(SANKEN communication protocol)
2: Modbus communication function
1 0
4006 Inverter No.
0
-
247
SANKEN protocol : 1
-
32
Modbus protocol : 0
-
247
1 1
4007 Communication speed 1: 1,200bps
2: 2,400bps
3: 4,800bps
4: 9,600bps
5: 19,200bps
6: 38,400bps
7: 57,600bps 1 4
4008 Parity bit 0: No
1: Odd
2: Even 1 1
4009 Stop bit 1: 1 bit
2: 2 bits 1 1
4010 End code 0: CR+LF
1: CR 1 0
4011 Specified command inverter's
response selection 0: Sent
1: Not sent (Error response sent)
2: Not sent (No error response sent) 1 0
4101 Modbus communication timeout
setting 0: No function
0.01 -600 sec. 0.01s 0
4102 Modbus communication timeout
action 0: Keep the status
1: Stop alarm
1 0
4103 Modbus register address switching 0: register number A
1: register number B 1 0