![background image](http://html1.mh-extra.com/html/sacmi/ccm001/ccm001_user-manual_3187258126.webp)
002AZ001A
8 - 20
8
MAINTENANCE
T2580
E -
Adjust trimmer N until the display reads zero Bar while the extruder is at a standstill.
Remove the protective screw seen from the outside in order to access trimmer N, located on the bottom of the
transducer body.
F -
Simulate the calibration pressure by placing a jumper between wires 752 and 753, leaving both wires connected.
Under this condition, the value displayed should be 80% of the nominal pressure value of the transducer (for 0
- 350 bar transducers the value should be 280 bar). If this value is not displayed, set trimmer B, located on the
bottom of the transducer, until the correct value is reached.
G - If trimmer B was adjusted, remove the jumper between wires 752 and 753. Zero set again by performing the
operations given at steps E and F.
H - Adjust transducer BP2, repeating the operations given at steps D, E, F and G. Work on wires 758 and 759 instead
of wires 752 and 753.
Figure 8.1.2.3.8 - CHECKING AND SETTING PRESSURE TRANSDUCERS BP1 AND BP2
SYSTEM
SYSTEM
Summary of Contents for CCM001
