Sacmi CCM001, User Manual

Page: 89 / 164

002AZ001A
7 - 3
ADJUSTMENTS
7
T2526
0
0,25
Figure 7.2.1 - INSERTION DRUM
9 Connecting rod
11 Eccentric pin
12 Plate
13 Comparator
14 Cam support
15 Disk
16 Pin
12
7.2 INSERTION DRUM
Conditions:
- Mode selector turned to SET-UP
The adjustments given below are to be made with the machine at the correct work temperature.
7.2.1 ADJUSTING THE PRECHARGE OF THE DRUM’S CONNECTING ROD
- Loosen the nut that secures the upper eccentric pin (11 or 16) located at the end of the connecting rod (9).
- Push the insertion drum inside the forming drum by hand. As a result, the pin (11) will be under the back plate (12).
- Place the magnetic strip of a comparator (13) on the surface (14) of the actuator cam’s support. The comparator’s
sensor should rest on the disk (15).
- Reset the comparator.
- Tighten the eccentric pin (11) (the comparator will detect the vertical movement of the disk 15) until 0.25 mm is read.
- Tighten the nut for the eccentric pin (11).
- Bring the pin (16) against the plate (12).
- Fully tighten the nut for the pin (16).
9
15
13
14
11
16