Sacmi CCM001, User Manual

Page: 69 / 164

002AZ001A
5 - 1
START UP
5
5 START UP
5.1 INTRODUCTION
Initial machine start up is to be carried out by personnel specialized in both the mechanical and electric fields.
E0004P
WARNING!
Solely the manufacturer’s technicians responsible for starting up the machine are authorized to carry out these
operations, as indicated in chapter 1, GENERAL INFORMATION.
Severe damage to the machine and/or serious injury to persons may occur if carried out by other persons.
See chapter 6, OPERATING INSTRUCTIONS, for detailed information regarding the control keys.
The customer’s machine operator and maintenance staff must simply look on when the machine is started up (to better
understand the operating principle of the machine, how to adjust the auxiliary equipment, accessories and safety
devices and guards employed) and trial runs are carried out to check the adjustments made.
5.2 PRELIMINARY CHECKS
CONDITIONS:
- machine hooked up to the supply and air mains.
PROCEDURE
- Make sure the air mains pressure is as required (see paragraph 2.3 SPECIFICATIONS).
- Make sure the hoses that join the forming unit to the hydraulic power unit are correctly attached (see chapter 4 -
INSTALLATION).
- Make sure the hoses that join the forming unit, extruder and hydraulic power unit to the temperature regulator are
correctly attached (see chapter 4 - INSTALLATION).
- Make sure the hoses that join the temperature regulator to the chiller (if provided) or central cooling system are
correctly attached (see chapter 4 - INSTALLATION).
- Check to see whether all the shut off valves are open.
- Check the oil level in the hydraulic power unit.
- Check all the safety devices for efficiency.