Sacmi CCM001, User Manual

Page: 139 / 164

002AZ001A
8 - 33
MAINTENANCE
8
8.1.2.5.13 Replacing gears G
- Loosen the screws (13, 14 and 16) and ring nut (17).
- Remove the parts left free by screw ( 14).
- Pull out the insertion drum. lifting the entire unit up from the cutter holder.
- Loosen the screws (18) at the worktable.
- Take out the cutter holder.
- Remove the snap ring (19).
- Remove the wheel (G) at a worktable with vice.
- Remove the screws (29) that secure the bearings.
- Remove the bearings and replace the wheel (G).
- Put the bearings back in (clean and grease them before hand), tightening screws (29) that secure the flange to block
the bearings for last.
- Close the pack of bearings with the snap ring (19).
- Install the cutter holder with the screws (18).
- Place the insertion drum on the drive shaft.
- Install the parts held in place by screws (14 and 16) and fully tighten.
- Fully tighten screw (13) and ring nut (17).
- Time the stripper wheel as directed in the ADJUSTING THE PELLET INSERTION STAGE paragraph in chapter
7.
8.1.2.5.14 Replacing gears H
- Loosen the screws (13, 14 and 16) and ring nut (17).
- Remove the parts left free by screw (14).
- Pull out the insertion drum. lifting the entire unit up from the cutter holder.
- Loosen the screws (18) at the worktable.
- Take out the cutter holder.
- Remove the snap ring (19).
- Remove the wheel (G) at a worktable with vice.
- Remove the snap ring (20).
- Take out the shaft (21) at a worktable with vice and remove the bearings remaining on the wheel (H).
- Put the wheel (H) back on part (21) using the bearings previously removed (clean and grease the bearings before
hand).
- Install the wheel (G) on part (H) (first clean and grease the bearings mounted between H and G).
- Install the cutter holder with the screws (18).
- Place the insertion drum on the drive shaft.
- Install the parts held in place by screws (14 and 16) and fully tighten.
- Fully tighten screw (13) and ring nut (17).
- Time the stripper wheel as directed in the ADJUSTING THE PELLET INSERTION STAGE paragraph in chapter
7.
8.1.2.5.15 Replacing pulley A
- Loosen the nut (4).
- Loosen the screws (40) that secure the tensioner so that the belt can be slackened.
- Loosen the screws (3) that secure the guard to the connecting rod.
- Loosen the self-locking ring nut (2).
- Loosen the screws (1) that hold the pulley in place and replace the pulley with a new one.
- Put belt (B) in place.
- Tighten the tensioner’s screws.
- Tighten screws (1) and ring nut (2).
- Tighten the tensioner’s nuts.
- Check and time the stripper wheel as directed in the ADJUSTING THE PELLET INSERTION STAGE paragraph
in chapter 7.