Sacmi CCM001, User Manual

Page: 147 / 164

002AZ001A
8 - 41
MAINTENANCE
8
8.1.2.7.1 Greasing and checking
- Check the condition of the cam raceway. If the raceway is worn, replace it without delay.
- Grease the cam raceway. To grease the actuator control cams, take off the covers (8) using the mounting screws
provided.
8.1.2.7.2 Replacing the stripper cams (central movement) (optional)
- Loosen the screws (9).
- Replace the cam (3).
- Position the cam as indicated on the “Data sheet”.
- Fully tighten the screws (9).
- Check the position of the cam.
- Grease the cam raceway.
8.1.2.7.3 Replacing the stripper cams (side movement)
- Remove seven stripper rods from the forming drum from the side opposite the operator, as indicated below.
Loosen the nut (10) (see figure 8.1.2.6 - FORMING DRUM).
- Pull out the stripper rod being careful not the damage the stripper (13) (see figure 8.1.2.6 - FORMING DRUM).
- Remove the stripper ring with the fork installed (see figure 8.1.2.6 - FORMING DRUM).
- Turn the drum manually until the part of the drum without any rods corresponds to the stripper cam.
- Loosen the screws (10).
- Replace the cam (4).
- Position the cam as indicated on the “Data sheet”.
- Fully tighten the screws (10).
- Check the position of the cam.
- Grease the cam raceway.
- Turn the drum manually until the part of the drum without any rods is on the side opposite the operator.
- Install the stripper rods.
- Install the ring (13) by inserting the fork (11) in the stripper rod and fully tightening the nut (10) (see figure 8.1.2.6
- FORMING DRUM) for all the rods.
8.1.2.7.4 Replacing the actuator control cams
- Loosen the screws (11 and 17).
- Take off the covers (12 and 18).
- Remove the pins (13).
- Loosen the screws (16).
- Remove the cam mount (15).
- Loosen the screws (14) and replace the cams.
- Carry out the operations in reverse order to put the parts back in place.
- Grease the cam raceway.
8.1.2.7.5 Replacing the cams for injecting air in the punches
- Loosen the screws (19 and/or 20) depending on the cam section to be replaced.
- Replace the cam and position it as indicated on the “Data sheet”.
- Fully tighten screws (19 and/or 20).
- Grease the cam raceway.