Sacmi CCM001, User Manual

Page: 118 / 164

002AZ001A
8 - 12
8
MAINTENANCE
8.1.2.2.2 Checking the oil level in the extruder geared motor and topping up
- Make sure the oil level, shown by the gauge (33), is correct. If it is not, top up as follows:
- Take off the cap (31).
- Add oil until the correct level (33) is reached.
- Screw the caps (31) back on.
8.1.2.2.3 Changing the oil in the extruder geared motor
- Take off caps (31 and 32); wait until all the oil has flown out of the geared motor or thrust block and then put the cap
(32) back on.
- Add oil until the correct level (33) is reached.
- Screw the caps (31) back on.
8.1.2.2.4 Cleaning the nozzle
- Remove any plastic compound that has built up on the nozzle (17) during operation. Be careful not to ruin the top
part where the cutters that cut the pellets pass by.