Sacmi CCM001, User Manual

Page: 66 / 164

002AZ001A
4 - 8
4
INSTALLATION
T2512
4.3.4 HOOKING UP THE PNEUMATIC SYSTEM
(References given in figure 4.3.4)
PNEUMATIC CONTROL UNIT
- Attach a hose whose inside diameter is as stated in the specifications to the fitting (A) from the compressed air supply.
PLASTIC COMPOUND FEEDER, located over the extruder hopper.
- Connect the tube B with quick-connect coupler provided on the extruder.
- Connect the plastic compound feeder to the pneumatic diverter control unit with the relative hose in the point marked
C in the figure.
The hose must have an inside diameter of 6 mm.
E0004P
WARNING!
The machine’s control unit is to be connected to the compressed air supply by the customer in compliance with
the regulations in force in the country where the machine is installed.
Figure 4.3.4 - CONNECTING THE PLASTIC COMPOUND FEEDER AND MAINS AIR
A Compressed air mains fitting
B Extruder quick-connect coupler
C Plastic compound feeder coupler
A
B
C