Manual
Double Sheet Detector-series I20
B0069991 / Rev. 1.7
Start-up
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
83
7.7.2
Program parameters for the (Monitoring parts for hardened / tempered
properties and materials mix up)
This menu structure is valid for the system type g (for details refer to chapter 3.2)
The program parameters contain the information required for the various measurement programs.
For accessing the program parameters, select the mode “configuration program parameter“ and
confirm with
ENTER
.
Program parameter 1:
Selecting the measuring program to be configured.
Fig. 53: Selecting the program to be configured
Here the measuring program (1-255) to be configured is selected. All following adjustments apply
to the selected program.
Program parameter 2:
Selecting the sensors to be used for measurement.
Fig. 54: Sensor number / Sequence
Here the sensor pair /sensor pairs is / are selected, which are to be used for measurement.
Possible choices:
• 1 / 2 / 3 / 4
• 1+2 / 1+3 / 1+4 / 2+3 / 2+4 / 3+4
• 1+2+3 / 1+2+4 / 1+3+4 / 2+3+4 / 1+2+3+4
Program parameter 3:
Setting the measuring frequency
Fig. 55: Setting the measuring frequency
According the measuring task is selected here the frequency. Different frequencies are available,
depending on the sensor type.
Note
A change deletes the values determined during the Teach-In and
therefore requires a new Teach-In.
Program parameter 4:
not available
Program Parameter: 1
Program Number
1
Program Parameter: 2
Sensor no./ Sequence
Program Parameter: 3
frequency
320 Hz
