Manual
Double Sheet Detector-series I20
System description
B0069991 / Rev. 1.7
30
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
Method b) simultaneously (sequencer)
Advantageous when measuring the same sheet thickness with each sensor. Here the addressing
of each sensor is done automatically by the I20. The inquiry of the sensors is predetermined in the
program.
Note
Advantage: Very fast measurements are possible, smaller software
effort on the PLC side.
Only one output is generated for connected sensors. The summary output is formed with the
following priorities: 2-sheet before 0-sheet, 0-sheet before 1-sheet.
The following is a typical application example
Note
The simultaneous measurement (sequencer) is also applicable for the
simultaneous measurement of sheets with different thickness, with the
following restrictions:
- the sheet thickness ratio must be less than 2:1
- each sheet thickness is controlled by a sensor pair
- the largest nominal sheet thickness is to be set. This will
issued as measurement at each sensor pair as measured value
- for Teach-In it must be used at each sensor pair a sheet which later
corresponds to the sheet thickness to be measured.
Start
Program Thickness Sensor
1
1,5 mm
1, 2, 3, 4
PLC
1. measure Pr.1
2. evaluate result Pr.1