Instrument Function
R&S
®
SMC100A
109
Operating Manual 1411.4060.32 ─ 04
5.3.2.2
Configuring RF Frequency
To change the RF frequency, press the FREQ key and enter the desired frequency.
Changes to the RF frequency have an immediate effect (without confirmation with the
ENTER key) on the output signal.
RF Freq
Enters the RF frequency, considering the frequency offset.
Note:
The SCPI command sets the level of the "Freq" display, i.e. an entered frequency
offset and multiplier factor are taken into consideration in the frequency value.
SCPI command:
5.3.2.3
Frequency Menu
In the combined "Frequency/Phase" dialog, you can enter the frequency, the frequency
offset and multiplication factor of a downstream instrument, set the step width for the
frequency entry using the rotary knob, and set the phase for the RF output signal.
To open the"Frequency/Phase" dialog, select "RF > Configure > Frequency" or use the
MENU key under "RF".
The "Frequency/Phase" dialog is divided into the several sections.
Frequency and offset of the RF output signal are set in the "Frequency Settings" section
in the upper part of the dialog. In addition, the multiplier factor of an externally connected
multiplier is specified.
The step width which is used when setting the frequency using the rotary knob (with
"Variation Active On") is set in the "User Variation" section.
RF Signal - RF Block
