Getting Started
R&S
®
CMW500
54
User Manual 1173.9463.02 ─ 02
In principle, a signaling test session involves the following steps.
1. Connect your MS to the R&S CMW500, preferably using one of the bidirectional RF
connectors RF 1 COM or RF 2 COM at the front panel.
2. Open the signaling firmware application and click/press ON | OFF until the signaling
control softkey indicates the ON state.
3. After the mobile has completed registration, set up a call from the mobile (call setup
occurs automatically in some applications, e.g. "WiMAX Signaling"). Wait until the
R&S CMW500 indicates that the call/connection has been established.
4. Perform any of the measurements included in the signaling application or related TX
tests.
The R&S CMW500 supports signaling applications for various network standards. The
features are largely standard-dependent. For an introduction and general hints on each
of the applications refer to the first sections, "General Description", in the relevant chap-
ters. The general features of the signaling applications are described in section
ter 4.4, "Signaling Applications"
The following figure shows the "WCDMA FDD Signaling" main view with an established
circuit switched connection.
Fig. 3-5: WCDMA FDD Signaling View
Sample Session
