TOPEX Bytton (HSPA+ / LTE)
ByttonLTE(full)_genericUsermanual_sw306FAS_revN.1.docx
Page: 75 / 290
Save this settings with Save then use Commit to make the changes permanent. Following a reboot, the
Bytton equipment starts operating with the new parameters, and now LAN1 and LAN2, although physically
active, are disabled from software. When you connect a cable to them, nothing happens!
The browsers will show you error messages such as:
Or:
The green LED in the connector lights up, and the yellow LED is permanently ON, it does not blink to
indicate data traffic – the respective Ethernet port is physically preset, but disabled by software!
On the computer connected to the disabled
ports of Bytton ICR, Network Status will
show “No Network access”, instead of the of
the normal display:
When you ask for details, it will show
Windows-default, not usable IP address of
169.254.43.24!
