TOPEX Bytton (HSPA+ / LTE)
ByttonLTE(full)_genericUsermanual_sw306FAS_revN.1.docx
Page: 42 / 290
3. WiFi Antenna
The antennas for the WiFi Access Point of Bytton ICR are stick-type, with an articulation near the
connector.
In case of Bytton LTE units equipped with WiFi b/g module, a single WiFi stick antenna must be
inserted.
Use the sleeve of the 90 degree bent to thread
the stick antenna into the circular male
connector on the front panel (marked “WiFi),
which is located in the middle, above the three
indicator LEDs, as shown in the following
drawing.
Figure 4-17: Attachment of a single WiFi Stick
Antenna
Dual WiFi connectors
Bytton LTE equipments fitted with “N” type access point may feature dual connectors for WiFi, to achieve
better coverage and higher bandwidth.
Thus you shall thread two stick antennas for WiFi!
Here also, you must observe the “Main” and
“Aux” indications written under the antenna
connectors:
Figure 4-18: Attachment of the two WiFi
Antenna for N-type wireless AP
Note that the connector for the Mobile network is female, while the connector for the WiFi antenna is male,
there is no risk of inserting the incorrect antenna.
Warning!
Don’t use excessive force when threading the antennas.
Make sure the antennas are securely screwed into the respective RF connectors, but do NOT use a
spanner or screw key, which could damage the antenna connector!
Tighten the flange lightly, by hand.
