TOPEX Bytton (HSPA+ / LTE)
ByttonLTE(full)_genericUsermanual_sw306FAS_revN.1.docx
Page: 191 / 290
List of current routes for each VT:
Route List Virtual Table VT1
target gateway source proto scope dev tbl
10.0.59.64/ 30 static link br0
10.0.0.0/ 24 static link br0
10.0.0.0/ 24 10.0.0.1 static br0
172.27.0.0/ 16 static link lan0
Route List Virtual Table VT2
target gateway source proto scope dev tbl
192.168.148.148/ 31 192.168.1.8 static wan
172.27.0.0/ 16 static link lan0
10.0.0.0/ 16 10.0.0.1 static br0
Route List Virtual Table VT3
target gateway source proto scope dev tbl
172.27.0.0/ 16 static link lan0
73.0.0.0/ 8 static link lan0
Route List Virtual Table VT4
target gateway source proto scope dev tbl
192.168.1.236/ 30 static link br0
10.0.0.0/ 24 static link br0
172.27.0.0/ 16 static link lan0
Figure 5-127: Examples of VT Routes listing.
Defining routes:
At first, this table is empy, so you must use Add New to create a new rule,
then choose for this route the IP and net mask, the router and / or the interface to be used, and the metric:
Figure 5-128: Define new Virtual Table entries.
These routes, being virtual, will not show up in the ROUTING>Routes page:
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
10.64.64.65 0.0.0.0 255.255.255.255 UH 0 0 0 ppp1
10.0.0.0 0.0.0.0 255.255.255.0 U 0 0 0 br0
192.168.148.0 0.0.0.0 255.255.255.0 U 0 0 0 wan
172.27.0.0 0.0.0.0 255.255.0.0 U 0 0 0 lan0
192.168.0.0 0.0.0.0 255.255.0.0 U 0 0 0 wan
0.0.0.0 10.64.64.65 0.0.0.0 UG 0 0 0 ppp1
