6 | Operation
RINCO ULTRASONICS AG
90 / 137
BA_Standard3000_GB_V5.1_36566
WARNING
Moving the actuator carriage WITHOUT the handwheel to
adjust the height:
Uncontrolled downward movement of the actuator carriage.
Danger of crushing!
• Hold the converter housing, then release the clamping
lever.
– Loosen the clamping levers
– Gently place the press with height adjustment on the welding object.
– Tighten both clamping levers.
– Tighten the clamps (12) using an Allen key. First gently tighten both
sides, then check proper alignment and tighten.
– Move the press to the upper rest position using the two-hand release.
– Remove welding object.
– Lower press again.
– Loosen the clamping levers and move the press downwards until the
welding stroke is in the lowest position while making sure that the
sonotrode is not in contact with the anvil. This ensures that the sonotro-
de and anvil cannot be damaged in idle stroke (no plastic part inserted).
– In the main menu under "Database/Parameter database“, select the
application you want and press F1 to load the data set or manually
enter the parameters.
– To process a new application, select a similar application from the
database with "Load data set". Change the project description and
press information under "Info".
NOTE
If you are not familiar with the welding technology, carefully
read through the chapter
Welding technology [
}
41]
. Then
adjust the settings and optimise your welding process.
Fig. 58:
Loosening the clamping
lever
Fig. 59:
Tightening the clamping
lever
Fig. 60:
Tightening the clamps
Fig. 61:
Moving to upper position
with two-hand release
