3 | Machine description
RINCO ULTRASONICS AG
30 / 137
BA_Standard3000_GB_V5.1_36566
Scale for actuator / trigger mark
The scale (8) is used to measure or adjust the actuator.
The safety switch is activated if the trigger mark (8.1) is crossed. The cycle
then continues automatically without actuation of the two-hand release
(6 mm).
Clamping lever for actuator lock
The clamping mechanism (9) for securing the press head after rough adjust-
ment.
Handwheel for height adjustment
The height of the press head is adjusted with the handwheel (10).
Manual check valve
The compressed air connection connects the compressed air system of the
press with the local compressed air mains.
The manual check valve (11) is used to isolate the energy between the local
compressed air mains and the compressed air system of the press.
Mounting clamps for the anvil
Socket clamping screws (12) for releasing and securing the anvil for parallel
alignment.
Quick guide
Quick information on the most important functions can be found in the quick
guide (13).
Pressure regulator DR
The pressure regulator (14) keeps the air pressure at the upper end of the
piston constant. The air pressure is set according to the size of the part, the
length of the weld seam and the material to be welded.
As a guideline, the regulator pressure can be set to approx. 3 bar for circular
parts with a surrounding weld seam with a diameter of 50 mm.
3.2.1.8
3.2.1.9
3.2.1.10
3.2.1.11
3.2.1.12
3.2.1.13
3.2.1.14
Fig. 8:
Pressure regulator DR
