RIGOL
© Copyright
RIGOL
Technologies, Inc. 2007
User’s Guide for DG1000 Series
1-8
To Set a Waveform
At the left of the operation panel, there is a set of buttons with waveform icon. See
Figure 1-9. The exercise below will help you to be familiar with the waveform
selection settings. The instructions of the waveform setting are all carried out in the
Menu Display Mode.
Figure 1-9
Waveform Selection Buttons
1.
Press Sine button, and the waveform icon turns into Sine with a “Sine” typeface
in the state area. DG1000 Series Generator can generate Sine signal with
frequency from 1
μ
Hz to 20MHz. By setting Frequency/Period, Amplitude/ High
Level, Offset/ Low level, sine signal with different parameters can be generated.
Figure 1-10
Sine Signal in the Menu Display Mode
As shown in Figure 1-10, the default signal parameters are: 1kHz Frequency, 5.0 V
PP
Amplitude and 0 V
DC
Offset.
2.
Press Square button, and the waveform icon turns into Square with a “Square”
typeface in the state area. DG1000 Series Generator can generate Square signal
with frequency from 1
μ
Hz to 5MHz and variable duty cycle. By setting
Frequency/Period, Amplitude/ High Level, Offset/ Low level, and Duty Cycle,
Square signal with different parameters can be generated.
Figure 1-11
Square Signal in the Menu Display Mode