INSTALLATION INSTRUCTIONS
SeaBat 8160
Operator‟s Manual
Page 17
October 6, 2011
Version 5
CAUTION
Do not install the monitor in a location near heat sources such as radiators or
air ducts, or in a place subject to direct sunlight, excessive dust, mechanical
vibration, salt spray, or shock.
Use equipment straps, clamps or other securing devices to ensure that the
installation is seaworthy.
4.2.4 Cable Connections
There are several cable connections to be made at the dry end of the installation.
These connections are between the sonar processor and its peripheral
equipment and between the sonar processor and the transceiver.
The critical connections are shown in
. All dry-end cables
come with factory-installed connectors and just need to be attached at the
appropriate port(s).
Figure 6: Sonar Processor, Rear Panel
CAUTION
When connecting the transceiver to processor cable, use a minimum bend
radius of 125mm or a minimum bend diameter of 250mm. A smaller bend
radius will result in damage to the cable.
Trackball
Monitor
Ethernet
Transceiver
AC Mains
