8
6. Safety notes
In case of damage caused by non-compliance with these operating instructions, the warranty/guarantee will expire. We do
not assume liability for any consequential damage.
We do not assume any liability for property damage and personal injury caused by improper use or non-compliance with
the safety instructions. In such cases the warranty/guarantee is voided.
Dear Customer: The following safety information is intended not only for the protection of the device but also for the protection of your
health. Please read the following items carefully.
a) General information
• For safety reasons, any unauthorized conversions and/or modifications to the product deviating from these operating instructions
are not permitted. Components may be damaged and thus impair the function or safety of the device.
• The mains unit corresponds to the applicable CE provisions. Compliance with the applicable CE provisions for the finished con
-
struction kit, whoever, is subject to the constructor of the construction kit and also essentially depends on precise work during
assembly.
• This device is a protection class I product. The voltage source must be a proper mains socket (230 V/AC, 50 Hz) of the public
mains with a protective ground contact.
• The mains socket to which the 3D printer is connected must be close to the device and easily accessible to quickly separate the
device from the mains voltage in case of an error.
• Attention, LED light:
Never look into the LED beam!
Never watch directly or with optical instruments!
• All persons who operate this product, mount, install, assemble it, put it into operation or service it must be trained and qualified
accordingly and must observe these operating instructions.
• The 3D printer is not suitable for persons with physical, sensor or metal limitations or for inexperienced or uninformed persons.
• This product is not a toy, not to be used by children and not suitable for children. Children cannot judge the dangers involved when
handling electrical devices.
• The mechanical parts of the product are produced highly precisely. Never apply any mechanical force here. The 3D printer may be
rendered useless by this.
• Do not leave any packaging material unattended. It may become a dangerous toy for children.
• If you are not sure of the correct connection or if there are any questions that are not covered by the operating instructions, do not
hesitate to contact our technical support or another specialist.
• Also observe the additional safety information in the individual chapters of these instructions.
b) Set-up, site of operation
• Set up the 3D printer only on a stable, horizontal, sufficiently sized surface.
• Choose the site of operation so that children cannot reach the product.
• When setting up the 3D printer, observe that the mains switch at the rear of the device must be easy to reach so that the device
can be switched off quickly and easily in case of malfunction.
• The devices must not be exposed to any extreme temperatures, strong vibrations, high moisture, such as rain or steam or strong
mechanical strain.
• Never place containers containing liquids, e.g. glasses, vases, etc. on the device or in its vicinity and do not pour any liquids out
over the device. Liquids may get into the housing and impair electrical safety. This also poses great danger of fire or potentially
fatal electric shock!
If this is the case, first power down the respective mains socket on all poles (e.g. switch off circuit breaker and FI switch) and
then pull the mains cable from the socket. Disconnect all lines from the device. Do not operate any part of the product anymore
afterwards, but take it to a specialist workshop.
• Never place any sources of open fire, such as lit candles, on or right next to the device.
• When setting up the product, make sure that the mains cable is not pinched or damaged by sharp edges.
