![Renkforce RF2000 v2 BSS Operating Instructions Manual Download Page 69](http://html1.mh-extra.com/html/renkforce/rf2000-v2-bss/rf2000-v2-bss_operating-instructions-manual_1441509069.webp)
69
Filament Settings
(1) Filament diameter and filament diameter tolerances according to the manufacturer's specifications are set here. If no manufacturer's speci
-
fication is present, these values can also be measured with a calliper (measure 1 m of filament material in 10 different points and then set
the average here).
(2) Temperature settings for extruder and heating bed separated by first and all other layers.
Observe the settings recommended by the filament manufacturer!
Since the best values may fluctuate extremely depending on the filament manufacturer, perform your own tests based on the pre-
settings to achieve the best printing quality. When performing the tests, proceed in 5 °C steps and compare the results during or after
printing with other settings. The first layer should always be printed a little more hotly for better adhesion on the heating plate.
(1) Here you can choose between automatic cooling and permanent operation of the fan at the extruder.
(2) Setting of the fan speed.
2
1
2
1