18
d) Setup and transport
When setting up the 3D printer, observe that the mains switch or the mains line at the low power device combination
socket must be easy to reach so that the device can be switched off quickly and easily or be disconnected from the voltage
supply in case of malfunction. The emergency off switch must be easy to reach as well!
Ensure proper ventilation when setting up the device. Do not put the device down on soft support such as a carpet or bed,
etc. the air circulation also must not be impaired by other objects. This prevents heat dissipation from the product and may
lead to overheating (danger of fire).
When setting up the device, make sure that it has a stable footing and place it on a stable underground. Persons may be
injured if the 3D printer drops.
When setting up the device, make sure that the connection cables are neither pinched nor damaged by sharp edges.
Always place the cables so that no one can trip over them or be caught in them. There is a danger of injury.
Never place the device on any valuable or sensitive furniture surfaces without sufficient protection.
• Put up the 3D printer on a level, stable and non-vibration-sensitive surface.
• When you want to transport the 3D printer, secure all other movable parts with adhesive tape or cable ties or best use the original packaging.
Use only the original packaging for shipping! Particularly note that the two parts of the original packaging are pushed onto the heat
bed.
We assume no liability for any transport damage caused by improper packaging of the printer!
e) Mains connection and first activation
The mains socket to which the 3D printer is connected must be close to the device and easily accessible to quickly separate
the device from the mains voltage in case of an error.
Do not let the mains cable come into contact with other cables.
Be careful when handling mains cables and mains connections. Mains voltage may cause potentially fatal electric shock.
Make sure that no cables lie around openly. Install cables professionally to prevent accidents.
Before plugging in the mains plug, ensure that the device voltage indicated at the 3D printer corresponds to the available
mains voltage. Do not connect the device if the indication does not correspond to the available mains voltage. Incorrect
supply voltage may lead to irreparable damage to the device and danger to the user.
If the printer suffers any malfunction or if there is any other problem, you can push the "emergency off switch" to quickly
disconnect the printer's voltage supply. Remove the problem before taking the printer into operation again. Then turn the
emergency off switch clockwise. This unlatches it.
• Plug the low power device plug of the mains line into the low power device combination socket at the rear of the device.
• Plug the mains plug of the mains line into a protective contact socket.
• Switch on the printer with the mains switch at the low power device combination socket (put the switch in position I).
• The lighting is low again and the display will briefly show the welcome screen and the installed firmware; then the main menu appears.
• The LED at the Z-limit switch (light barrier) is lit red permanently.
