High-performance Embedded Workshop
17. Using the Debugger
REJ10J1837-0100 Rev.1.00 Nov. 16, 2008
285
To locate files
1.
The
Last searched directory
holds the last directory that was searched for these module files.
2.
The
Search status
field shows the number of files that were found against the number that have not - this is
only relevant to the files in the dialog and do not account for any previous searches.
3.
The
Files to find
list holds a list of all the files that could not be found, they will appear in short filename
format, and will be searched for in this manner.
4.
The
Browse
section allows the user to select a directory in which to search the remaining files for.
5.
The
Look in subdirectories
check box will look for the files in all sub-directories for the chosen directory.
6.
The
Do not show on download
check box will not bring up this dialog box on download if there are files that
can not be located. This checkbox is also present in the
Confirmation
tab of the
Options
dialog box, and can
be turned off and on here.
7.
Pressing
Search
will look for the files in the
Browse
list in the chosen directory, files that have been found
will be removed from the
Files to find
list.
Any searched directories in the
Browse
section will be shown by a folder and magnifying glass icon (
).
Once the user has selected
Search
this button will be changed to a
STOP
button allowing the user to cancel a
search. Any files that had been found before the search was cancelled will return to the unlocated state.
8.
Clicking
OK
, then the files that were searched for and found will be located to that directory, accept all
searches, and close the dialog box.
9.
Clicking
Cancel
completely cancel all searches that have been done, and close the dialog without changing
anything.
If you had done some searches and they clicked on cancel a confirmation box will appear as below;
If you select
Yes
this will invoke the Locate Files dialog box and close the dialog box. If you select
No
the dialog box
will remain open allowing you to select OK. If the confirmation is selected not to be shown again, the default behavior
will be
Yes
.
To open the confirmation dialog box again
1.
Select [
Setup -> Options
]. The
Options
dialog box will be displayed.
2.
Select the
Confirmation
tab.
3.
Select the
Show dialog to search on OK for directory browse dialog
checkbox. This checkbox is selected by
default.
4.
Click
OK
.
If you select the OK button after selecting a directory, and not selecting search, a confirmation box will be shown, as
below.
