Instruction manual
Page 52 / 189
Copyright © REA Elektronik
REA JET HR
pro
2K / 4K
V 3.5x_001 28.05.2015
Figure 37: Assembly position of the two screws to connect two print heads
Figure 38: Fastening point of the double stripper plate on the print head
The screw connection of the stripper plate are at the side. The force- and form-fit assembly is done
with two screws (2) one on each side of the housing of the print head. On the lid side only the lower
fastening hole (3) is used. This screw is only used to intercept a potential tilting torque, e.g. when a
product is stuck or twisted behind the stripper plate. This screw is not used to position or fasten the
stripper plate. This screw is a grub screw that can only be screwed in approx. 2/3 of its length.
2
3
