R&S AREG800A, User Manual

Page: 112 / 411

Configuring the operation setup
R&S
®
AREG800A
112 User Manual 1179.3615.02 ─ 01
"Origin" Sets the object reference to "Origin".
"Mapped Sen-
sor" Sets a mapped sensor as object reference, see Chapter 6.3.1, "Over-
view" , on page 84.
Remote command:
[:SOURce<hw>]:AREGenerator:OSETup:REFerence
on page 338
Data Source
Requires "Mode > Dynamic".
Sets the data source for the dynamic operation.
"Scenario" Sets for dynamic radar object simulation scenarios.
"HiL/ViL" Sets the data source to hardware in the loop (HiL) or vehicle in the
loop (ViL) scenarios.
Remote command:
[:SOURce<hw>]:AREGenerator:OSETup:SOURce
on page 338
HiL - Protocol
Requires "Data Source > HiL/ViL".
Sets the protocol type for hardware in the loop (HiL) or vehicle in the loop (ViL) scenar-
ios.
"ZMQ" Sets zero message queue (ZMQ) asynchronous messaging library.
"DCP" Sets distributed co-simulation protocol (DCP).
Remote command:
[:SOURce<hw>]:AREGenerator:OSETup:PROTocol
on page 338
Host IP Adress/ Hostname
Requires "Data Source > HiL/ViL".
Sets the IP address or hostname of the instrument for hardware in the loop (HiL) or
vehicle in the loop (ViL) scenarios.
Remote command:
[:SOURce<hw>]:AREGenerator:OSETup:HOSTname
on page 337
Host Port
Requires "Data Source > HiL/ViL".
Sets the host port of the instrument for hardware in the loop (HiL) or vehicle in the loop
(ViL) scenarios.
Remote command:
[:SOURce<hw>]:AREGenerator:OSETup:PORT
on page 338
Show Connector
Accesses a dialog that displays the physical location of the selected connector on the
front/rear panel of the instrument.
Apply
Applies the settings of the current operation setup configuration.
Operation Setup settings