R&S AREG800A, User Manual

Page: 349 / 411

Remote control commands
R&S
®
AREG800A
349 User Manual 1179.3615.02 ─ 01
Example: See Example "Detecting and assigning a power sensor"
on page 345.
Usage: Event
Manual operation: See "Clear" on page 100
:SLISt:CLEar[:ALL]
Removes all R&S NRP power sensors from the list.
Example: See Example "Detecting and assigning a power sensor"
on page 345.
Usage: Event
Manual operation: See "Clear" on page 100
:SLISt:ELEMent<ch>:MAPPing <Mapping>
Assigns an entry from the
:SLISt[:LIST]?
to one of the four sensor channels.
Parameters:
<Mapping> SENS1 | SENSor1 | SENS2 | SENSor2 | SENS3 | SENSor3 |
SENS4 | SENSor4 | UNMapped
Sensor channel.
*RST:
UNMapped
Example: See Example "Detecting and assigning a power sensor"
on page 345.
Manual operation: See "Sensor Mapping List" on page 100
:SLISt:SENSor:MAP <SensorId>, <Mapping>
Assigns a sensor directly to one of the sensor channels, using the sensor name and
serial number.
To find out the the sensor name and ID, you can get it from the label of the R&S NRP,
or using the command
:SLISt:SCAN[:STATe]
. This command detects all R&S NRP
power sensors connected in the LAN or via 'USBTMC protocol.
Setting parameters:
<SensorId> string
<Mapping> enum
Example: See Example "Detecting and assigning a power sensor"
on page 345.
Usage: Setting only
Manual operation: See "Sensor Mapping List" on page 100
SENSe, READ, INITiate and SLISt subsystems