Radyne OM20, Installation And Operation Manual

Page: 169 / 220

OM20 Universal Outdoor Modem Appendix B
MN-OM20– Revision 5 B–3
B.4 Demonstration Procedure
The procedure for enabling a 30-day demo of the OM20 options is similar to the procedure used
for permanently updating the modems feature set. The one big difference being that at the end of
30 days, the demo features will automatically be disabled and the modem will revert back to its
permanent configuration.
At the end of the demonstration period, when the modem reverts back to
its permanent configuration an interrupt in traffic will occur, regardless of
whether or not a demo enabled features was being run at the time. In
addition, operator intervention may be required to restore the data paths.
In order to avoid this interruption in service, the user can cancel the
demonstration at any time by following the instructions outlined in the
section on “Canceling Demonstration Mode.”
1. The following steps allow users to quickly determine from the GUI Interface whether
or not the desired feature(s) are supported by the hardware currently installed in the
modem.
Using the GUI interface navigate to the Features menu under “System” gel-tab. Click on
“features”. This will show the available features and all features checked are the
purchased/installed features.
2. Contact Radyne with the Unit ID and Request a Demonstration. The modem’s Unit
ID can be found in the Terminal interface as follows:
a. From the main menu, the Features menu.
b. “Feature Id: is the unit ID number