Radyne ComStream TIERNAN SE4000, Installation And Operation Manual

Page: 113 / 161

Troubleshooting SE4000 MPEG-2 Contribution Encoder
6-10 01-0934-401-B
no front
panel fault S/W Error:
VxWorks
internal signal
caught. Internal software error. Reset the unit.
If normal operations do not resume,
contact the Radyne ComStream
Customer Service Department.
no front
panel fault S/W Error:
Hardware
exception
caught Internal software error> Reset the unit.
If normal operations do not resume,
contact the Radyne ComStream
Customer Service Department.
TAB.x Init TAB. X Init
Error Table Initialization Error Power cycle the unit.
If normal operations do not resume,
contact the Radyne ComStream
Customer Service Department.
VE.x Init VE.x Init Error Video Encounter
Initialization Error Power cycle the unit.
If normal operations do not resume,
contact the Radyne ComStream
Customer Service Department.
VE.x
EncOvrflw VE.x ENC FIFO
Overflow Video FIFO (first in, first
out) Overflow MUX rate is set too low.
Recalculate all bit rates and enter correct
rates, or select AUTO mode.
VE.x
PesOvrflw VE.x PES FIFO
Overflow Video PES (packetized
elementary stream)
Overflow MUX rate is set too low.
Recalculate all bit rates and enter correct
rates, or select AUTO mode.
VI.x
FormatErr VI.x Format
Mismatch Analog Video Format
Mismatch. Input format
does not match set
configuration Verify that the source format matches
configuration.
If unit continues to fail, contact the
Radyne ComStream Customer Service
Department.
VI.x Gen
Loss VI.x Loss of
Genlock Analog Genlock Input is not
present. If Genlock source was enabled, ensure
input source is in proper video format and
conforms to specified input levels.
If the unit continues to fail, disable
GenLock.
VI. x Init VI.x Init Error Video Initialization Error Power cycle the unit.
If normal operations do not resume,
contact the Radyne ComStream
Customer Service Department.
VI. x Inp
Level VI.x Input Level
Large Analog Video Input Too
Large Ensure that the input source is in proper
video format and conforms to specified
input levels.
Adjust video input signal levels.
Ensure video is terminated.
VI.x Inp
Level VI.x Input Level
Small Analog Video Input Too
Small Ensure that the input source is in proper
video format and conforms to specified
input levels.
Adjust the video input signal levels.
VI.x Inp Loss VI.x Loss of
Input
Video Main Input Not
Present If the unit is functioning normally, clear
faults and continue operations. If faults
continue, check connections, ensure input
source is in proper video format and
conforms to specified input levels.
If unit continues to fail, reset unit.
VI.x Ovrflw VI.xD1 FIFO
Overflow Ditgital Video D1 Video
FIFO (first in, first out ) is
full If the unit is functioning normally, clear
faults and continue operations. If faults
continue, check connections, ens ure input
source is in proper video format and
conforms to specified input levels.
If unit continues to fail, reset unit.
VI.x Ovrflw VI.x FIFO
Overflow Analog D1 Video FIFO (first
in, first out ) overflow If the unit is functioning normally, clear
faults and continue operations. If faults
continue, check connections, ensure input
source is in proper video format and