Radyne ComStream TIERNAN SE4000, Installation And Operation Manual

Page: 100 / 161

SE4000 MPEG-2 Contribution Encoder Configuring the SE4000
01-0934-401-B 5-3
3. A message appears to confirm the selection. This helps to prevent accidental re-
configuration. Press Enter to continue.
SE4000/QUICKSET/DVB >
Press Enter to restore DVB Config.
4. A “last chance to turn back” menu appears. Press Enter to continue.
SE4000/QUICKSET/DVB >
(ENTER) = Restore Config, (EXIT) = abort
5.
Various screens will appear indicating that the unit is re-configuring and then resetting.
The process takes less than 1 minute. Once the basic SE4000 power on screen appears,
the unit is ready for operation or configuration.
SE4000 >
[QUICKSET] SERVICE OUTPUT STATUS
5.1.2 Using a Remote Unit to Set the Default Configuration
To initialize the SE4000 to the default configuration using a remote unit issue the following
command:
CM RESTORE <string>
, where
<string>
is the default parameter such as
DVB
or
ATSC
.
When the SE4000 is set to the default setting, the remote port baud rate is
set to 38400 bps. If the remote unit is set to communicate with the
SE4000 at a baud rate other than 38400 bps, immediately after the default
command is issued, the remote unit will not be able to communicate with
the SE4000. To resolve this issue, the equivalent parameter in the
software settings of the remote unit must be changed to 38400 bps.
However, the remote unit software settings must not be changed before
issuing the default command to the SE4000, as the remote unit will not be
able to communicate with the SE4000.