Radyne ComStream TIERNAN SE4000, Installation And Operation Manual

Page: 146 / 161

SE4000 MPEG-2 Contribution Encoder Table Top/Rack Mount Installation Instructions
01-0934-401-B E
-1
Table Top/Rack Mount Installation Instructions
E
This appendix presents step-by step instructions for the installation of Tiernan 1U, 2U, and 4U
products. Instructions are presented for installing products:
Instructions are for installation of 1U, 2U and 4U products. A 2U product
is shown for illustrative purposes.
•
On a table top
•
Using front rack mount brackets
•
Using rear rack mount brackets
E.0 Table Top Installation
To install a Tiernan unit on a tabletop or other flat surface, install the rubber feet included in the
shipping kit, or place the unit on a rubber mat or other material that will prevent the unit from
sliding and protect the table top surface.
Ensure that the unit is placed on a stable surface of sufficient size and strength where it will not
be jarred or pushed off its surface. Ensure that all cables and cords are out of the way and that
they will not be tripped over, as this may cause personal injury or serious damage to the unit.
To install the rubber feet, perform these steps:
1.
Ensure that there are four rubber feet included in the shipping kit.
2.
Break the feet apart from one another. Working with one rubber foot at a time:
a. Remove the protective backing.
b. Make sure the bottom of the unit is clean.
c. Place the foot under one corner of the unit, with the sticky side against the unit.
3.
Press the foot firmly against the unit. When you are finished, there should be one rubber
foot under each corner of the unit.
4.
Ensure that the unit’s location and position provide the minimum required air flow
clearance.
E.1 Rack Mount Installation
To install a Tiernan unit in a standard 19- inch equipment rack using front mounting brackets,
perform these steps: