RADVision SCOPIA 400, User Manual

Page: 45 / 208

Installing the SCOPIA Gateway 35
Initial Gateway Configuration
C
ONNECTING TO A
PC
This section describes how to use the serial port connection to configure the
Gateway with an IP address.
Procedure
1 Locate the terminal cable shipped with the Gateway.
2 Connect the end labeled PC to the serial port on the computer.
3 Connect the end labeled Unit to the serial port connector on the
Gateway front panel.
Note The PC terminal should have an installed terminal emulation application,
such as HyperTerminal.
S
ETTING THE
IP
A
DDRESS
This section describes how to use the serial port to configure the unit with an
IP address and other address information.
The serial port on the Gateway front panel is used to assign a new IP address to
your Gateway. You must assign the IP address before you connect the Gateway
to the network.
Before You Begin
Gather the items listed in Table 2-6 to assign an IP address to the Gateway.
Table 2-6 Requirements for Setting the IP Address
Requirements Notes
Dedicated IP address for the Gateway
IP address of the default router the Gateway
uses to communicate over the network
PC with available serial port and terminal
emulator software installed
RS-232 terminal cable (shipped with the
unit)