RADVision SCOPIA 400, User Manual

Page: 110 / 208

100 SCOPIA 400/1000 Gateway User Guide
Configuring Gateway Settings
Procedure
1 In the Gateway interface, on the sidebar, click Gateway (if not already
selected).
2 Click the Settings tab.
3 Click Quality of Service .
4 In the Quality of service support field, select one of the following option
buttons:
None —Select to disable quality of service support.
Default (recommended) —Select to assign the default DiffServ
Code Point value for each media type.
Custom —Select to assign your own DiffServ Code Point value for
each media type. You can configure the following additional
settings:
In the Control Priority (0-63) field, enter a whole number from
0 to 63 to set the DiffServ Code Point value of signaling packets
that the Gateway sends out. The default value is 26.
In the Video Calls section Voice Priority (0-63) field, enter a
whole number from 0 to 63 to set the DiffServ Code Point value
of voice packets that the Gateway sends out. The default value
is 46.
In the Video Priority (0-63) field, enter a whole number from 0
to 63 to set the DiffServ Code Point value of video packets that
the Gateway sends out. The default value is 34.
In the Data Priority (0-63) field, enter a whole number from 0
to 63 to set the DiffServ Code Point value of data packets that
the Gateway sends out. The default value is 26.
(PRI Gateways only) In the Voice Calls section Voice Priority
(0-63) field, enter a whole number from 0 to 63 to set the
DiffServ Code Point value of voice packets that the Gateway
sends out. The default value is 46.
Note You can click Restore Defaults to restore all default settings.