Prophete INDEX-14, Operating Instructions Manual, Page: 158 / 444

66 EN
CHAIN
chain is appropriately tensioned.
4. Attach the wheel with the axle nuts on both sides with a 15
mm wrench. Tighten the axle nuts according to the torque
specification (s. chapter torque specifications).
SHIMANO NEXUS INTER 3
1. Use the shifting lever to put in the 1st gear.
2. Release the attachment screw
217
.
3. Remove the switchbox.
4. Pull the switching pin that you can now see from the axle bore.
5. Loosen the screw of the brake counter-holder
220
with a screw-
driver.
6. Release the axle nuts on both sides of the rear wheel with a 15
mm wrench.
7. Shift the rear wheel to adjust the chain tension. Ensure that the
wheel is placed straight in the holder.
8. Attach the counter-holder bracket with the pipe clamp screw
connection
220
at the frame.
9. Push the switching pin into the axle guide on the right to the
stop.
10. Push the switchbox onto the right axle nut as shown.
11. Fasten the switchbox with the lower attachment nut
217
.
12. Set the gearshift (s. chapter Gearshift).
GEAR HUB WITH DISK BRAKE
1. Use a 5-mm Allen wrench to undo the two screws
221
+
224
on
both sides of the frame
2. Use a 5-mm Allen wrench to undo the fixing screw
222
on both
sides.
3. Now shift the rear wheel to adjust the chain tension (
225
). To do
so, screw in the fixing screw
222
until the correct position has
been reached. Make sure that the wheel is straight when seated
in the holder and that the chain is properly tensioned (see Che-
cking the chain tension chapter)
4. Tighten the screws
221
+
224
firmly (see Torque specifications
chapter).
217 218 219
220
221
222
223 224
225