Prophete INDEX-14, Operating Instructions Manual, Page: 151 / 444

Eng
lish
EN 59
GEARSHIFT
GEARSHIFT
HUB GEAR
OPERATING THE GEARSHIFT
To shift a gear, you need to turn the shifting rotating grip. Stop pedalling briefly while shifting gears to
permit the gear to shift.
ADJUSTING THE GEAR / INSTALLING AND REMOVING THE REAR WHEEL
You can find descriptions for setting the different shifting systems and removing/installing the rear
wheel below:
SHIMANO NEXUS INTER 3
SETTING THE GEAR SHIFT
1. Use the turning rotary handle to shift from the 1st to the 2nd
gear.
2. Check that the yellow mark
180
is centred within the two limi-
tation lines
181
.
3. If the gear shift must be adjusted, release the counter-nut
first
183
.
4. Then set the gear shift with the setting screw
184
.
5. Tighten the counter-nut
183
again well after setting.
6. Check the correct function of the gear shift by shifting through
the gears several times.
REMOVING THE REAR WHEEL
1. Use the shifting lever to put in the 1st gear.
2. Release the attachment screw
182
at the switchbox.
3. Remove the switchbox.
4. Pull the switching pin that you can now see from the axle
bore.
DANGER OF ACCIDENT!
• Incorrectly installed wheels may impair braking and cycling performance.
• Tighten all screws and nuts that you loosened again well. Check that the safety
washer is placed correctly. The rear wheel may otherwise come loose during
the ride! Perform a careful test ride after installation.
DANGER
180
181
182
183 184