Prophete INDEX-14, Operating Instructions Manual, Page: 117 / 444

Eng
lish
EN 25
QUICK-CLAMP
QUICK-CLAMP
A quick-clamp comprises a lever
69
/
71
that produces the clamping force
and a counter-screw
68
or knurled nut
70
that sets the pre-tension.
Release the quick-clamp by flipping over the lever. To close, push the lever
back again until it is completely flush. On the first half of the closing
movement, the lever must move relatively easily; on the second half, it
must move much stiffer. If this is not the case, the quick-clamp must be
adjusted, since it does not have enough tension.
SETTING THE QUICK-CLAMP
1. Release the lever
69
/
71
of the quick-clamp.
2. Adjust the pre-tension with the hexagonal screw
68
with a 5 or 6 mm
hexagonal socket wrench. For quick-clamps with knurled screw
70
,
you can adjust the settings manually.
3. Push the quick-clamp lever
69
/
71
back again with enough force. The
lever must be flush entirely.
SET THE AXLE QUICK-CLAMP
1. Release the lever
72
of the axle quick-clamp.
2. Set the pre-tension with the clamping nut
73
3. Push the quick-clamp lever
72
back again. The lever
must be flush entirely.
68
69
70
71
DANGER OF ACCIDENT!
• Ensure before starting your ride that all quick­clamps are closed with sufficient
tensing force. If the quick­clamps are not closed sufficiently, parts may come
loose.
• The lever of the quick­clamp must be completely flush and must not stand off!
Wheel quick­clamps and frame quick­clamps always must point backwards for
reasons of safety (when viewed in the cycling direction).
• If the quick­clamp lever generally can be closed very easily or trusted when clo­
sed, the pre­tension will not be sufficient. Adjust the quick­clamp then.
WARNING!
OPEN
CLOSE
CLOSE
73
72