Prophete INDEX-14, Operating Instructions Manual, Page: 153 / 444

Eng
lish
EN 61
GEARSHIFT
REMOVING THE REAR WHEEL
1. Use the turning rotary handle to shift to the 1st gear.
2. V-brake rim brake: Disconnect the brake cable
189
in order to take
out the wheel more easily later.
Hydraulic rim brake: Open the quick-clamping lever
181
of the rim
brake [OPEN].
3. Hydraulic rim brake: Take the brake cylinder
192
off the cantilever
socket
193
in order to take out the wheel more easily later.
4. Release the brake counter-holder on the left side of the E-bike
194
.
5. Release the axle nuts on both sides of the rear wheel with a 15
mm wrench.
6. Take the two axle nuts including the safety washers
195
off the
axle.
7. Pull out the rear wheel from the drop-out.
8. In order to release the rear wheel from the shift cable, turn the
circlip
196
by approx. 45° counter-clockwise. Now you can dis-
connect the circlip and the actuating lever from the rear wheel.
INSTALLING THE REAR WHEEL
1. Place the actuating lever on the hub of the rear wheel. Observe
that the yellow marks of the actuating lever cover the yellow
marks of the hub
197
.
2. Place the circlip on the actuating lever and turn it by approx.
45° clockwise. (
196
+
197
)
3. Place the rear wheel into the drop-out.
4. Apply the safety washers on the axle so that the interlock is in
the drop-out (
198
).
5. Fasten the rear wheel with the axle nuts. Ensure that the wheel
is placed straight in the holder and that the chain is appropri-
ately tensioned (see chapter Chain tension).
6. Attach the counter-holder bracket on the left side with the pipe
clamp screw connection at the frame (
194
).
7. V-brake rim brake: Connect the brake cable
189
again.
Hydraulic rim brake: Push the brake cylinder
192
back onto the
cantilever socket
193
.
8. Hydraulic rim brake: Close the quick-clamping lever
191
[CLOSE]. If the lever closes too easily, the quick-clamping screw
must be adjusted (see chapter Brakes).
9. Check that the rim brake works properly. Adjust it if necessary
(s. chapter Brake).
10. Set the gearshift (s. chapter Setting the gearshift).
194 195
193
191
192
ratched
monting ring
rotate by 45°
for mounting align the
yellow markings on each
other
fix the bracket to the switch arm
properly
196
switching arm
cover
note
direction
yellow marker
yellow marker
drive unit
ratched
align
197
backup disk
chapping nut
198