Pitney Bowes relay 2000, Operator'S Manual

Page: 61 / 92

OMR Scanning • 4
4-9 SV63139 Rev.A
Select Feed (SF1, SF2)
These marks are used to control the feed of material from the feeder
holding the supplementary inserts on a set-by-set basis.
Use
Select Feed 2
marks in the primary sheet feeder to select material
from the insert feeder. For C- and double fold, the primary feeder is sheet
feeder 1.
Auto Batch
This mark identifies the last set of a batch, when the batch function is
in use. It must appear on all sheets of the OMR set that requests this
function.
Wrap Around Sequence (WAS1, WAS2, WAS3)
This is a numbering system which uses a sequential binary coding. If a
page is missing or the set goes out of sequential order, the system stops
processing and declares an error.
Three wrap around sequence marks are used within the code. The use of
three binary digits allows a decimal count of 0 to 7. Pages are numbered
from 0 up to 7, and then back to 0 on a continuous cycle throughout the
print run.