Pitney Bowes relay 2000, Operator'S Manual

Page: 14 / 92

1 • System Overview
1-6 SV63139 Rev. A
Control Panel Identification
Use the buttons on the system control panel to set up and run jobs. The
display screen shows the system status.
9
10
11
8
1
7
4
3
5
6
2
1
Clear Deck - Press to jog material through and out of the
inserter. Also use it to clear the inserter and make it ready for
automatic operation after a stoppage has occurred.
2
Trial Piece - Press to run a single test piece to check inserter
setup. You must run a trial piece before you begin automatic
operation using the
Start
button. If double detection is
enabled, the inserter sets itself automatically to run the trial
piece. The trial piece envelope will be unsealed and counted
as one item.
3
Delete - Press while in setup mode to delete a programmed
job from memory.
4
Setup - Press to enter the setup mode. This mode allows you
to program jobs into memory for instant recall using the
Job
button.
5
Change + – - In setup mode, press to select options or set
values of inserter settings.
6
Prev ◄ ► Next - In setup mode, press to step backward or
forward through the various job settings.