Pitney Bowes relay 2000, Operator'S Manual

Page: 22 / 92

2 • Program a Job
2-4 SV63139 Rev. A
Scanning and Non-Scanning Jobs
If OMR scanning functionality is enabled on your system, operators can
turn scanning on and off depending on the job. If scanning functionality is
not available on your inserter, your job setup will differ slightly.
Refer to the table below to review the steps that apply to your job type and
follow the step-by-step instructions provide in this section.
Scanning and Non-Scanning Job Sequence
Scanning Jobs Non-Scanning Jobs
Enable scanning (OMR On or Off) Disable scanning (OMR Off) if
available on your inserter.
(Skip if you
inserter does not have scanning)
Set fold type Set fold type
Set main (scanning) sheet feeder Set accumulation
Set second/supplementary feeder Set sheet feeder 1
Set the sealer Set sheet feeder 2
Set paper length Set insert feeder
Set fold A /fold B Set mode type (insertion or fold)
Set envelope depth Set the sealer
Set envelope stop Set paper length
Set batch counter Set fold A /fold B
Confirm job setup Set envelope depth
Run a trial piece Set envelope stop
Set batch counter
Confirm job setup
Run a trial piece