Pitney Bowes relay 2000, Operator'S Manual

Page: 40 / 92

2 • Program a Job
2-22 SV63139 Rev. A
Modify an Existing Job
To modify an existing job follow these steps. (This requires Supervisor
level access.)
1. Press
Setup to enter setup mode.
2. Press Change ( +/- ) to increase or decrease to access code 71 .
3. Press Next (►) to accept the code and advance to the job selection.
4. Use Change ( +/- ) to display the job you wish to modify.
5. Press Next (►) to accept the job selection and advance to the job
programming settings.
6. Use Prev (◄) and Next (►) to scroll through the settings.
7. When you find the desired setting, use Change ( +/- ) to scroll through
the options and/or values you want.
8. Press Next (►) to accept the job setting.
9. Press Setup to exit the setup mode and save the changes.
Delete a Job
To delete an existing job from the inserter system follow these steps. (This
requires Supervisor level access.)
1. Press
Setup to enter setup mode.
2. Press Change ( +/- ) to increase or decrease to access code 71 .
3. Press Next (►) to accept the code and advance to the job selection.
4. Press Change ( +/- ) to display the job you wish to delete.
5. Press Delete . The display reads “Press again to confirm.”
6. Press
Delete
again. The display briefly reads “Deleting Job” as the job
is erased.
7. Press Setup to exit the setup mode.