Piper Aircraft Corporation Malibu Mirage PA-46-350P, Airplane Maintenance Manual

Page: 1000 / 1956

PAGE 6
Feb 28/07
5F10
34-50-00
PIPER AIRCRAFT, INC.
PA-46-350P, MALIBU MIRAGE
MAINTENANCE MANUAL
(3) Post Installation Setup Procedure
(PIR-PPS-60206 REV. H.)
Access the Configuration Mode of the unit by depressing and holding the FUNC key while
applying power to the unit. Release the FUNC key when the display activates. The FUNC key
sequences forward through the configuration pages. The START/STOP key reverses through
the pages, stopping at the Menu page. The CRSR key highlights selectable fields on each
page. When a field is highlighted, the 0-9 keys enter numeric data and the 8 or 9 keys move
through list selections. Press the CRSR key to accept changes. When a field is highlighted,
pressing the FUNC key moves to the next configuration page without saving the changes. To
exit the configuration pages, turn the power off and then turn the unit on again without holding
the FUNC key for normal operation.
NOTE: When the unit it turned on for the first time, or an invalid address is recognized, the
unit will prompt the user to enter a valid aircraft address. See Mode S Address (ICAO
Aircraft Address Code) and FLIGHT ID Entry Page paragraph, below.
(a) Configuration Menu
The JUMP TO menu page provides the capability to select a configuration mode starting
page without having to step through all of the pages. Press the CRSR key and sequence
through to the desired section with the 8 and 9 keys. Jump to the selection by pressing the
CRSR key again with the desired selection highlighted. The FUNC key steps to the next
configuration page, after which the START/STOP key reverses until stopping at the JUMP
TO menu page. Following is a list of selections and their descriptions
SELECTION DESCRIPTION
DIAGNOSTICS Jumps to Gray Code Input Page
DISPLAY/AUDIO Jumps to Audio Volume Page
I/O CONFIG Jumps to ARINC INPUT #1 Page
ACFT CONFIG Jumps to Operation Configuration #1 Page
(b) Refer to Charts 9-15 for required settings on the configuration pages.
Function Selection Description
VOLUME MAX
VOICE MALE
MESSAGE (0-5) Selected Audio Tones and Messages
0= Toggle a continuous tone on and off
1= Attention Tone, precedes voice messages to
attract the pilot’s attention.
2= “Leaving Altitude”, when altitude monitor is
active and the altitude deviation is exceeded.
3= “Traffic”, when a TIS traffic alert is received.
4= “Time Expired”, when the countdown expires.
5= “Traffic Not Available”, when TIS service is not
available or out or range of an operating TIS
MODE S site.
6-9 are not used.
ALTITUDE MONITOR OFF When Altitude Pre-Select is installed.
TONE When Altitude Pre-Select is not installed.
PAGE CHANGE ENABLE
COUNTDOWN TIMER TONE
CHART 9
VOICE AND VOLUME