Piper Aircraft Corporation Malibu Mirage PA-46-350P, Airplane Maintenance Manual

Page: 460 / 1956

PAGE 6
Feb 28/07
2J22
25-10-00
PIPER AIRCRAFT, INC.
PA-46-350P, MALIBU MIRAGE
MAINTENANCE MANUAL
D. To install Lumbar bladder
CAUTION: CARE MUST BE TAKEN WHEN USING THE APPROVED SOLVENTS AS THEY
HAVE A LOW FLASH POINT. SOLVENTS SHOULD NOT BE USED IN CLOSE
AREAS WHERE APPLICATOR CANNOT GET SUFFICIENT FRESH AIR FOR
BREATHING.
NOTE: Acetone cleans well but evaporates so fast that it is difficult to wipe dry before solvent
evaporates.
(1) Surfaces to be joined shall be clean, dry, and oil free. Abrade rubber or plastic surfaces lightly
with Scotch Brite
TM or fine sand paper and then clean with solvent again.
(a) Surfaces shall be thoroughly cleaned by wiping with a clean cloth wet with solvent
followed by wiping dry with a clean cloth before the solvent evaporates. The cleaning
operation shall be repeated using a new clean cloth until all soil and grease is removed as
evidence by a clean cloth after wiping. Clean cloths and clean solvent shall be used in the
cleaning operation.
(b) APPROVED SOLVENTS: Acetone 193-035
Citra-Safe 279-112
Safe Care 193-051
Dupont 2319S/Plastic Prep. 279-081
Isopropyl Alcohol 179-918
(2) Apply a layer of 3M Scotch Grip 2210 or Delta Laboratories contact adhesive B-10161 (P/N
179-853) cement to rough side of bladder pad.
(3) Apply a layer of 3M Scotch Grip 2210 or Delta Laboratories contact adhesive B-10161 (P/N
179-853) cement to seat back filler where bladder is to be located.
(4) Allow the adhesive to dry for 15 minutes minimum, 60 minutes maximum.
NOTE: If the adhesive is allowed to dry more than 60 minutes, another coat may be applied to
one of the surfaces, and then bonded after 15 minutes minimum. Both surface do not
need to be tacky to achieve a bond.
(5) Assemble materials when adhesive is dry to touch, but tacky under slight pressure. Position
the surfaces to be joined carefully before allowing adhesive to adhesive contact.
NOTE: Repositioning after contact will not be possible without destroying the bond. If this
occurs, the adhesive shall be removed and the process repeated.
(6) Press firmly into position over the entire area of the bond.
(7) Install seat back filler cover and secure velcro fastenings.
(8) Install seat in airplane.
3. Carpets
The carpets are individually fastened to the floor with Velcro fasteners and adhesive (Hysol EA9309 NA).