Piper Aircraft Corporation Malibu Mirage PA-46-350P, Airplane Maintenance Manual

Page: 967 / 1956

PAGE 21
Feb 28/07 5E1
34-20-00
PIPER AIRCRAFT, INC.
PA-46-350P, MALIBU MIRAGE
MAINTENANCE MANUAL
9 Replace 7.3.7, Radar Sensor; and 7.3.12.7, Radar Setup, with the following:
Setup
If configuring a replacement MFD, start with step (a). In all other cases start with step (f).
a From the maintenance page, depress LSK (R3) to access the RADAR Set-up
page.
b Using the right outer concentric knob to select the configuration field and the
right inner concentric knob to select the desired configuration.
c From the RADAR Set-up Page select the following:
Sensor: AlliedSignal ART-2000 ARINC 429
Port: ARINC 429 Tx 1 ARINC 453
Port: ARINC 453 1
d Press SAVE. (After pressing SAVE, MFD goes to maintenance Setup Page)
e From the Maintenance Setup Page, press Restart System.
f Re-enter Maintenance Setup Page, depress LSK R3 to access the RADAR
Setup Page.
g Using the right outer concentric knob to select the configuration field and the
right inner concentric knob to select the desired configuration. Configure the
Radar Setup page for the following conditions:
Radar Sensor: AlliedSignal ART-2000
Park Position: Centered
Beam Width: 7.0 °
Beam Height: 7.0 °
All boxes CHECKED, except “Disable Stabilization” is NOT CHECKED.
Press SAVE. (After pressing save, MFD goes to Maintenance Setup Page)
Calibration
The R/T Configuration Module must be configured using the Allied Signal KPA 900
Configuration Module Programmer Kit (Part Number 050-03311-0002) in conjunction
with a personal computer. See the configuration module user data for detailed setup
instructions. Follow the instructions for the programmer.
Perform radar R/T calibration as follows: Reference AlliedSignal (Bendix/King) 2000
Radar Sensor installation manual.
Antenna Clearance Check
a From the Maintenance Set Up Page Select RADAR.
b Set the radar park position to Full Up. Enter SAVE.
c Restart the MFD. (SYSTEM) (R5)
d From the Radar Page, set the Radar Function to SBY. (L3)
e Set the Radar Mode to GND. (R1) Set KNOB to gain (L5)
f Reduce the gain until the gain indicator shows the minimum setting.